This series of hydraulic presses is suitable for the pressing process of plastic materials, such as stamping, bending, flanging, thin plate stretching, etc. In addition, it can also be used for calibration, pressing, powder product molding, and non-metallic material pressing molding. This series of presses has two electrical control systems, relay control and PLC control, with three operation modes: adjustment, manual and semi-automatic. It can achieve two process modes: constant pressure and constant stroke. During constant pressure molding, there is a pressure holding delay and automatic return action after compression. There is a top out device installed in the middle of the workbench, except for the top out products. It can still be used as a hydraulic pad for the forming process of anti stretching parts, and its working pressure and stroke can be adjusted within the specified range according to the process needs.

Model parameters:

Nominal pressure 10000KN

Main cylinder return force 1600KN

Top output 1600KN

The maximum working pressure of liquid is 25MPa

The maximum stroke of the slider is 1000mm

The maximum stroke of the top cylinder is 350mm

The maximum distance between the slider and the workbench is 1500mm

Sliding block travel speed: rapidly descending 80mm/s, working 6-10mm/s, returning 60mm/s

Top cylinder stroke speed: 80mm/s when pushed out, 120mm/s when retracted

The effective area of the workbench is 1500mm on both sides and 1500mm in front and back

The center distance of the column is 1700mm left and right, 1100mm front and back

The workbench is 800mm above the ground

Motor power 62KW

Machine weight ≈ 60000Kg