Product Introduction:
The Y5-47 boiler centrifugal induced draft fan consists of an impeller, a casing, an air inlet, a transmission part, and a regulating fan. The fan has two transmission modes, C and D, with water-cooled integral bearing seat and air volume regulating door.

Product Description:
Due to the large number of industrial boiler series, the quality of coal used varies greatly, and the resistance of the dust collector used is also different. The required air volume and pressure of the induced draft fan for the Y5-47 boiler centrifugal induced draft fan vary greatly. In order to adapt to the above situation, considering the economy of the fan, except for the induced draft fan with a 20 ton boiler that requires a higher power and uses a (D type) coupling for direct transmission, all others use triangular tape (C type) transmission. This not only allows different speeds to meet the requirements of the same tonnage boiler configuration type of dust collector with one machine number, reducing the number and series of fans, but also facilitates the unit to change the main shaft speed according to the actual situation to obtain the desired ideal air volume. Wind pressure. Suitable for those with similar intake conditions and performance, but the maximum temperature should not exceed 250 ° C.

Main parameters of Y5-47 boiler centrifugal induced draft fan:
The centrifugal induced draft fan of Y5-47 boiler can be made into two types: left rotation and right rotation. Looking at the fan from the transmission part, if the impeller rotates clockwise, it is called right rotation, represented by "right", and counterclockwise rotation is called left rotation, represented by "left". The position of the air outlet of the fan is represented by the angle of the air outlet of the casing. Both "left" and "right" can be made into three angles: 0 °, 90 °, and 180 °.

Jingong one-stop service: