VIP member
Wire and cable combustion tester for detecting injectors
Wire and cable combustion tester for detecting injectors
Product details
|
||
PSB wire and cable combustion tester for detecting injectors |
||
|
PSB-1KW gas spray lamp 1. Dimensions of the supporting combustion chamber 730*680*2620mm 2. Effective size of combustion chamber: 1200 ± 10 × 300 ± 10 × 450 ± 10mm 3. Standard power of combustion blowtorch: 1KW 4 The use of gas blowtorch is powered by propane or liquefied petroleum gas 5. The adjustment range of the air flow meter is 0-10 ± 0.51/mm (600L/H) 2、 Installation of the device 1. Placing the device in a suitable location can connect the top exhaust pipe, allowing it to be smoothly discharged outdoors. |
||
|
||
|
2. Connect the 220V power supply, with a maximum power of approximately 100W. 3. Connect the air compressor gas source and propane gas source according to the standard. |
||
 |
||
 |
||
| PSB-I-7T 1、 This equipment is mainly used for detecting the flame resistance of bundled wires and cables. The rear of the injector is connected to a fish tail shaped or round mouth spray lamp, and the design of the spray lamp complies with GB/T8380.3-2001 or BS EN50200:2006 standards. 2、 GB/T8380.3-2001 Basic Parameters Air flow rate: 77.7 ± 4.8L/min, pressure 0.1MPa (g) Propane gas flow rate: 13.5 ± 0.5L/min Flame length detection: 170-200mm 3、 BS EN50200:2006 Basic Parameters |
||
Online inquiry
-
Contacts
-
Company
-
Telephone
-
Email
-
WeChat
-
Verification Code
-
Message Content
-