Welded high-pressure flame arresterModel:GZ-I

Welded high-pressure flame arresterGenerally, stainless steel is used as the valve body and fire-resistant layer material, forged and manufactured, resistant to high temperature and high pressure, and suitable for flame passing through narrow pores of thermal conductors,Due to heat

A device designed and manufactured based on the principle of extinguishing due to loss of quantity, to prevent the spread of flames. Widely used in combustible gas pipelines, such as gasoline, kerosene, light diesel, benzene, toluene, crude oil and other oils

The storage and torch system, gas purification and chemical system, gas analysis system, coal mine gas emission system, heating furnace fuel gas pipeline network can also be used for acetylene, oxygen

Pipeline supplies for nitrogen and natural gas.

Welded high-pressure flame arresterProduct Parameters:

Shell material:304、304L、316、316L

Nominal pressure:PN2.5- 32 Mpa

Nominal diameter:DN15～DN50

Applicable media: gases such as nitrogen, natural gas, acetylene, oxygen, etc

Connection method: Welding

Filter material: stainless steel304、316Flame retardant corrugated board

Manufacturing materials:1Cr18Ni9Ti﹑304﹑316﹑316L﹑12Cr1Mov

Welded high-pressure flame arresterPerformance characteristics:

1The explosion-proof performance is qualified and continuous13The secondary explosion resistance performance test can block fire every time.

2Qualified fire resistance performance, fire resistance test1There is no tempering phenomenon within hours.

3The shell water pressure test is qualified. This product has a reasonable structure, light weight, and corrosion resistance. Easy to maintain and install. The flame arrester core is made of stainless steel material,

Corrosion resistant and easy to clean.Welded high-pressure flame arrester

1Purpose:

2On pipelines transporting flammable gases.

3Torch system.

4Oil and gas recovery system.

5The pipe network for heating furnace fuel gas.

6Gas purification and chemical system.

7Gas analysis system.

Coal mine gas emission system.flame arresterstandardExecution standards:GB13347-92Fire resistance performance and test methods of flame arresters for petroleum gas pipelinesSH/T3413-99

The Petrochemical IndustrySelection, Inspection, and Acceptance of Gas Pipeline Flame ArrestersHG/T20570.19-95The setting of flame arresters. Production, inspection, and acceptance standards for flame arresters:SY/T0512-1996

The StoneOil storage tank flame arrester ", testing basis:GB5908-86

Performance and experimental methods of flame arresters for oil storage tanks.Maintenance and repair of welded high-pressure flame arresters

:

1In order to ensure the performance of the pipeline flame arrester reaches the goal of full use. Fire arresters should be regularly inspected and maintained.

2The flame arrester should be inspected every six months to check whether the flame arrester core is blocked, deformed, corroded, etc.

3The blocked fire-resistant layer core should be cleaned thoroughly to ensure that each hole on the core is unobstructed, and any deformed or corroded fire-resistant layer should be replaced.

When reinstalling the fire-resistant layer core, it should be ensured that there is no air leakage at the joint surface.Shanghai Nanshi is a professionalflame arrester

Manufacturer, products produced by the company: breathing valves, flame arresters, flame retardant breathable caps, fire-resistant vacuum pressure caps, aluminum alloy ball valves

Aluminum alloy single flange ball valve, oil discharge port, double door bottom valve, oil measuring hole and other supporting accessories.Welcome to visit our website【http://www.shhxfcj.com】,.If you have any questionsYou can call us,

We will do our best to provide you with high-quality service.Telephone: