Detailed description:

The specialized magnetic vibration table for wall bricks is suitable for both sintered and non sintered bricks. Sintered bricks include sintered ordinary bricks, sintered porous bricks, sintered hollow bricks and hollow blocks (hereinafter referred to as hollow bricks); Non sintered bricks include autoclaved sand lime bricks, fly ash bricks, slag bricks, and carbide bricks.

The specialized magnetic vibration table for masonry bricks is a device that uses eccentric vibration and electromagnetic suction principles to vibrate and adsorb specimens. It is mainly suitable for the preparation of compression strength test specimens for masonry bricks, as well as for the vibration of other samples.

The implementation standard for the specialized magnetic vibration table for wall bricks is GB/T25044-2010 "General Requirements for Equipment for Preparing Compressive Strength Test Samples of Wall Bricks".

Main specifications, models, and technical parameters of the specialized magnetic vibration table for masonry bricks:

1. Vibration frequency: 2850r/min;

2. Suction force: 750N;

3. Power supply voltage: 380V;

4. Merit      Rate: 2.0KW;

5、 振      幅： （0.5±0.1）mm；

6. Total weight: 285kg;

7. Dimensions: (1000 * 1000) mm;

Instructions for using a specialized magnetic vibration table for masonry bricks:

1. Adjust the preset dip switch on the program controller panel to the required vibration time (in seconds). It is strictly prohibited to adjust the preset dip switch during the vibration process.

2. Place the test molds filled with concrete in the corresponding positions of the electromagnet, turn on the electromagnet switch on the control panel, and the test molds will be firmly fixed on the vibration table.

3. Press the start switch on the controller panel, and the vibration table will start. When it reaches the predetermined vibration time, it will automatically switch to braking. After 7 seconds, it will automatically power off.

4. Turn off the electromagnet switch, disconnect the trial mold from the table electromagnet, and then you can move the trial mold.

Maintenance of specialized magnetic vibration table for wall bricks:

1. After the vibration molding is completed, the remaining concrete on the countertop should be cleaned thoroughly.

2. Vibration motors and suspension bearings should be regularly lubricated with oil.

3. After use, the power should be cut off.

4. Electromagnets should not be energized for too long, otherwise the coil is prone to burning out.