VIP member
Small aluminum-plastic blister packaging machine
Introduction: Product Introduction: Using PVC and PTP as the main packaging materials, this machine is suitable for various sizes of plain tablets, su
Product details
Product Introduction:
Technical Specifications:
Using PVC and PTP as the main packaging materials, it is suitable for various sizes of plain tablets, sugar coated tablets, capsules, capsules, and shaped tablets of granular drugs,This machine is a gallbladder type internal heating aluminum-plastic machineBlisterpackaging machineDue to the use of advanced fluorine coating technology on the surface of the heating roller, PVC is uniformly heated and the foam cover is formed firmly. There is no foam loss during shutdown and startup, avoiding waste of packaging materials. Bubble suction, filling, mesh heat sealing, batch printing, and plate punching can all be operated continuously. Easy installation, debugging and maintenance, reasonable structure, compact size, light weight, low price, it is the crystallization of high-tech.
Product Features:
Product Features:
1. The 130 aluminum-plastic blister packaging machine is a miniature blister packaging machine with a small volume and compact structure.
2. The entire machine adopts gear transmission, with a reasonable mechanical layout, low operating noise, and easy installation and maintenance.
3. Equipped with a universal feeding machine, suitable for filling and packaging materials of different shapes.
4. It has the function of batch number printing. (Customization required)
5. The packaging is sealed reliably, the bubble cover is firm, and the plates are straight and beautiful.
Technical Specifications:
Product model: DPT-100/110/120/130/135/140/145/150
Packaging material: PVC130 × 0.25mm/PTP130 × 0.02mm
Molding depth: maximum: 16m
Packaging efficiency: 40000 to 80000 pieces/h
Punching frequency: 20-35 times/min
Packaging scope: Flat tablets, capsules, sugar coated tablets, irregular shaped tablets
Water consumption: 2.91L/min
Power consumption: 3.0KW
Voltage: 220V/380V
Dimensions: (length X width X height) 1600 × 800 × 1240
Whole machine weight: 280kg
technological process:
technological process:
1. Turn on the power switch and open the water supply valve;
2. Press the preheating switch, heater switch, and set the forming temperature to around 155 degrees.
3. Place the PVC hard sheet slightly past the stepping wheel.
4. Press the main motor start switch, soak the PVC for 3 meters, and then press the stop switch.
5. Insert the bubble strip into the machine position, slightly step over the roller, and enter the stainless steel guide plate on the die.
6. When the temperature displayed on the temperature controller is around 200 degrees, lay the aluminum foil and open the feeder gate, then press the heater motor switch.
7. Turn on the main motor start switch, close the mesh roller, and the machine will start working fully.
Mold replacement:
Mold replacement:
Cut off the water source, open the two drain screws on the cover, and remove the accumulated water in the rolling mold cavity. Unscrew the 2 hexagon socket screws on the sealing cover, remove the sealing cover, use a special tool to remove the round nut that fixes the rolling die, pull it out from the spindle, and then install the rolling die in reverse steps. Be careful not to scratch or damage the surface of the rolling die during disassembly. During installation, a small amount of engine oil should be applied to the mating surface, and attention should be paid to checking whether the O-ring seal is intact. After installation, the moon shaped valve should be tightly attached to the end face of the rolling die.Replacement of stepper rollerUnscrew the nut of the stepper roller and pull out the stepper roller.Synchronous adjustment of stepper mechanism and punching mechanism
Online inquiry
-
Contacts
-
Company
-
Telephone
-
Email
-
WeChat
-
Verification Code
-
Message Content
-