Introduction to slow-release sterilizer

1、 Product features:

AFHSThe slow-release sterilizer adopts dissolution method,Automatic slow-release,Design of pressure chlorination process,To include80%The aboveCLSolid pharmaceuticals are the main raw materials,Disinfectant produced by rational mixing and slow-release of water and chemicals,Put it into the required pool(well)Fully contact with water for sterilization and disinfection.

2、 Installation and usage instructions for slow-release sterilizer:

Inlet, connection power water, water pressure requirements0.20MPabelow,If it exceeds the rated water pressure,A pressure reducing valve must be installed in advance.--The outlet (disinfectant mixture) directly contacts the raw water in the water tank (well) or is connected to the inlet pipe of the water pump.--Add medication（CL）Remove the top cover, rotate the medicine chamber cover, add the required amount of medicine, and cover the seal

Connect the power supply and turn on the indicator power switch (indicator light on) to start (non powered equipment does not require power).

Gradually open the inlet ball valve and adjust it from small to large to the required flow rate for the outletL/min.

Residual chlorine monitoring, monitor the residual chlorine in the factory water on the second day, adjust the dosage and flow rate based on the results, and monitor the residual chlorine at the end of the pipeline network three days later

.

3、 Reference Table for Model, Medication, and Flow Control of Slow Release Disinfectors: