RX5 series water splashing sailor holding test device (IPX5 IPX6 waterproof)

application

This device is designed according to the requirements of IEC60529-89 and GB4208-93 standards. This test device is suitable for the second characteristic digits 5 and 6 of the enclosure protection level (IPX mark) (water spray and water spray tests). During the test, clean water with a constant flow rate should be used.

This device can meet the standards of GB4208-93, GB2423, IEC60529, etc. Used for testing the protection level of the shell.

structure characteristics

• Material: The box is made of SUS304 stainless steel. Nozzle material: SUS304 stainless steel
• Control panel: operation buttons (power, flushing 1, flushing 2, turntable, load timer, test timer)
• Main configuration: turntable, load, 2 flow meters, 2 booster pumps, 2 pressure gauges, 2 timers, valves, nozzles, high-pressure hoses, 5 meters each for each nozzle, and power distribution control cabinet.
• Distribution control cabinet: grounding board, main power leakage circuit breaker
• Standard configuration: 1 cable, 5 cores (4 wires+protective grounding wire), equipment user manual, warranty card, 1 certificate of conformity
• Protection device: leakage protection.

Controller

• Time controller: IS~9999H
• Pressure gauge: pointer type
• Flow meter: 0~1000L, 1M3~10M3
• Boosting pump: 1 IPX5, 1 IPX6

Technical specifications: PX 5

• Test method name: Water spray test;
• The test condition is that the inner diameter of the spray nozzle is 6.3mm;
• Keep the distance between the test sample and the water spray nozzle at 2.5m-3m, with a water flow rate of 12.5 L/min (750 L/h)
• Test time: Calculated based on the surface area of the tested sample shell, 1 minute per square meter (excluding installation area), with a minimum of 3 minutes

Technical specifications: IPX 6

• Method name: Intense water spray test
• The inner diameter of the spray nozzle is 12.5 mm
• Test conditions: Keep the distance between the test sample and the water spray nozzle at 2.5m-3m, with a water flow rate of 100 L/min (6000 L/h)
• Test time: Calculated based on the surface area of the tested sample shell, 1 minute per square meter (excluding installation area) for a minimum of 3 minutes.