The reverse osmosis purified water equipment adopts fully automatic control mode to reduce the impact of human error operation on the equipment belt. The design of a reduction system in the pretreatment system addresses the irreparable impact of excessive residual chlorine on the reverse osmosis membrane. Imported reverse osmosis membranes are used in the selection of reverse osmosis membranes, which have a long service life and lower effluent conductivity5us/cmThe high degree of automation, simple operation, stable water quality, and low operating costs have been highly praised by customers.

Instructions for each component and accessory of the equipment

1. Raw water tank: mainly solves the problem of unstable tap water pressure, reducing mechanical failures caused by frequent start-up or unstable tap water pressure during the operation of the lift pump.

2. Quartz sand filter: Tap water enters from the upper end of the tank and flows evenly from the upper end of the filter layer to the lower end through the upper water distributor. After passing through the filter layer, tap water is separated from the filter layer by the lower water distributor, forming filtered water.

3. Activated carbon filter: The internal structure of the activated carbon filter is identical to that of a quartz sand filter. After adsorption by activated carbon, the residual chlorine in tap water can generally be reduced to below 0.1mg/l.

4. Precision filter: mainly uses melt blown filter cartridges, which can remove small particles and further create conditions for reverse osmosis inlet water.

5. High pressure pump: provides the necessary power for reverse osmosis operation.

6. Reverse osmosis system: The reverse osmosis system is the core component of reverse osmosis pure water equipment. In the design of reverse osmosis, the number, brand, and arrangement of filter membrane elements are mainly considered.

7. Pure water tank: used for storing pure water.

Inlet water and environmental requirements

Power supply:380V 50Hz

Inlet water temperature: 5-45℃

Water ingressPH value: 3.0-10.0

Water ingressSDI (15 minutes)<5

Inlet turbidity<2NTU

Free residual chlorine concentration<0.1ppm

The device should be placed indoors to avoid accelerating the aging of its mechanical components.