FR2060The non-contact phase detector is a major breakthrough in traditional phase sequence detection methods. Traditional phase sequence detection requires disconnecting the terminals of three-phase wires and connecting the three exposed clips or test pins of the phase sequence meter to the three exposed live wiresFR2060Adopting a clamp shaped non-contact induction measurement method, there is no need to disconnect the wires or touch the high-voltage exposed live wire. Simply clamp the insulation outer skin of the three-phase live wire with three super induction high insulation clamps to detect the phase sequence. At the same time, the sound and light indicate the positive or negative phase status of the three-phase power supply phase sequence.
FR2060The non-contact phase detector has functions such as live line inspection, simple electrical inspection, circuit breaker search, breakpoint positioning, and line maintenance.
FR2060The non-contact phase detector has fast and convenient detection, with clear display, greatly improving the safety of on-site testing, effectively protecting the personal safety of operators, and increasing productivity! It is a safety instrument for three-phase power phase sequence, motor detection, and line maintenance!

work ability	Phase detection (positive and negative), live line inspection, simple electrical inspection, phase loss judgment, circuit breaker search, breakpoint location, and line maintenance.
electricity source	The 9V battery has a continuous usage time of about 70 hours.
Measurement method	Non contact wire clamping method
Wire position	The measured wire is in the center position of the clamp
frequent rate	50Hz/60Hz automatic recognition
Active power range	AC70-1000V, 45/65Hz (sine wave continuous input), static electricity detection.
Measure the highest voltage	AC1000V
Clamping wire size	Outer diameter ø 1.5mm to ø 48mm
apparent show	Four phase detection lights are sequentially lit in a clockwise direction;
	Four phase detection lights are sequentially lit in a counterclockwise direction;
	The L1, L2, and L3 lights are lit within the voltage setting range;
	[Phase loss] L1, L2, or L3 lights are not on;
	[Open circuit] The L1, L2, or L3 lights are not on.
wasp cry	The instrument emits intermittent short beeps;
	The instrument emits a continuous long beep sound.
Battery check	After turning on, the POWER indicator light of the power supply is on; The LOW BATTERY light is on when the battery is low.
Clamp the lead wire length	0.6m
Instrument size	117.6mm in length, 81mm in width, and 25mm in thickness
Automatic shutdown	After about 6 minutes of startup, the instrument panel automatically shuts down to reduce battery consumption
battery voltage	When the battery voltage drops to about 5.2V, the low battery voltage symbol is displayed, reminding to replace the battery
Instrument quality	Instrument: 260g (including battery)
Maximum rated power	300mVA
Working temperature and humidity	-10℃～55℃； Below 80% RH
Storage temperature and humidity	-20℃～60℃； Below 90% RH
Dielectric Strength	3.7kVrms
Suitable for safety regulations	EN61010-1：2001、EN61010-031：2002、 Pollution level 2, CAT III (600V), instantaneous overvoltage 6000V.