1. Full hot air reflow soldering is a welding method that uses convection jet nozzles or heat-resistant fans to force airflow circulation and achieve heating of the welded parts. This type of equipment began to rise in the 1990s. Due to the fact that the temperature of printed circuit boards (PCBs) and components using this heating method is close to the gas temperature in the given heating temperature zone, it completely overcomes the local temperature difference and shielding effect of infrared reflow soldering, and is currently widely used.

2. To extend the service life of the motor, our technical personnel specialize in designing it; Promote internal cooling circulation convection to lower the temperature around the motor to around 38 ℃;

3. High quality high-temperature and high-speed motors operate smoothly, with minimal vibration and low noise;

4. Professional wind turbine design, stable wind speed, effectively preventing the uniformity of wind when the PCB board is heated, achieving high repeated heating;

5. Each temperature zone adopts forced independent circulation, independent PID control, and up and down independent heating methods to ensure accurate and uniform furnace temperature and large heat capacity;

6. An online UPS equipped with power-off protection function ensures normal output of the PCB board after power failure, without damage;

7. Independently controlled cooling system, forced air cooling; The temperature of the PCB board after production is ≤ 50 ℃;

8. The insulation layer is made of high-quality aluminum silicate insulation material, and the furnace is designed with multiple layers of insulation. The surface temperature of the furnace body is about 5 degrees higher than the ambient temperature, effectively reducing the working environment temperature. The insulation effect is good, the temperature rises quickly, and the temperature from room temperature to working temperature is ≤ 20 minutes; Special furnace core design, with the lowest power consumption among peers;

Installation instructions for Guangshengde medium-sized six temperature zone full hot air reflow soldering GSD-6MN equipment

1、 Selection of installation location

First, select the installation location to ensure that the workplace meets the following requirements:

1. Provide sufficient space for maintenance and operation of the machine;

2. Adequate lighting;

3. A smooth ventilation system.

The machine will be installed on a non elastic, sturdy, horizontal ground that can withstand the weight of the machine.

2、 Height and horizontal correction

The machine is equipped with foot cups and moving rollers. When it is necessary to move the machine, raise the foot cup to manually push the machine. After ensuring that the ground is level, select the position for the machine, then unscrew the foot cup and adjust the level of the machine.

3、 System connection

The main power supply is connected to the three pole circuit breaker of the control box from the machine output board end, and the wiring should be firm. The diameter of the power supply line should not be less than 25mm ² (recommended to use 25mm ²).

4、 Power inspection and connection

When using the machine for the first time, due to transportation reasons or loose wires, attention should be paid to checking the connection of the machine's power lines. Check whether the terminal electrical equipment is well connected, whether there are fragments or other debris falling into the connection or exposing the wiring. First, remove the debris, connect the wiring, and then close the electrical box and furnace cover.

5、 Attention: Ensure that the power supply delivered to the machine is matched with the required power supply. If it cannot be matched, do not connect the power to the machine.

Guangshengde medium-sized six temperature zone full hot air reflow soldering machine is mass-produced and available in stock; Welcome customers and distributors from all over the country to place orders

Special reminder

1. Guangshengde reflow soldering equipment is insured by Ping An Insurance Company of China, with a compensation amount of up to five million yuan. Guangshengde reflow soldering provides greater assurance for customer safety production.

2. Purchasing Guangshengde reflow soldering equipment can be paid in monthly installments. For more details, please consult Guangshengde.