Equipment Name:Large motor drying oven/motor coil curing oven/motor stator rotor drying oven

We can design and customize the most suitable oven for you based on the characteristics of the material baking process. Consultation Hotline:

Purpose: Install a small explosion-proof door on the back of the motor coil oven box. When the pressure inside the box is too high, the explosion-proof door on the back will automatically pop open to achieve the effect of pressure reduction and explosion prevention. The motor box adopts a hot air circulation constant temperature heating method, with temperature control and uniform temperature difference, which can meet the drying, drying, curing, softening, and preheating needs of various industries.

Box structure material:

1. Outer wall material of oven: usingA3Cold rolled steel plate welding production, surface sprayed with silver gray hammer pattern self drying paint after treatment

2. Studio materials:A3Cold rolled steel plate, coated with high-temperature resistant silver powder paint on the surface

3. Strengthen materials:5#Angle steel and8#Channel steel reinforcement

4. Layered inside the box: The box is not divided. Configure one flatbed car

5. There are two grooves at the bottom of the oven for easy entry and exit of the drying area by the trolley

Flat car (trolley): The car is made of welded channel steel, and the surface can be flattened with steel plates according to customer needs, which can withstand2.5TThe above gravity. Four pulleys are installed at the bottom of the car for the car to push. Facilitating the entry and exit of materials and providing equipment efficiency

Oven temperature control section:

1. Temperature controller: using intelligent temperature control instruments,PIDAdjustment, with automatic temperature control and constant temperature function.LEDDisplay, Instrument

The upper row represents the actual temperature inside the box, while the lower row represents the temperature set by the user. When the actual temperature inside the box is the same as the set temperature

It can achieve temperature to start timing and time to alarm prompt. (Temperature can be controlled in stages and at different times according to customer requirements)

2. Heating element: A tubular heating tube is used, and the shell material is carbon steel pipe.

3. Installation position of heating tube: inside the air ducts on both sides of the oven liner

4. Oven operating temperature: room temperature--250Degree, maximum achievable300Degree, adjustable at will

5. Temperature control sensitivity: positive or negative1linear measure

6. Heating rate:5--6linear measure/min

Explosion proof door system: Install a small explosion-proof door at the back of the box. When the pressure inside the box is too high, the explosion-proof door on the back will automatically pop open to achieve the effect of pressure reduction and explosion prevention.

Hot air circulation section:

1. Blower motor:2The high-power blower motor is installed at the top of the oven

2. Air supply method: Strong pressure air supply method means that the oven is equipped with guide ports on both sides, and hot air is drawn out from the guide ports on the left and right sides of the box, with suction in the middle.

3. Install a high-temperature resistant long shaft motor at the top, with the wind turbine connected to the motor, to ensure that there is a large amount of hot air circulating inside the drying area and providing constant temperature timing function1S—99.99HThe constant temperature time can be set arbitrarily between them. When the constant temperature time is reached, the heating power supply will be cut off and an alarm will be triggered

Thermal insulation material between boxes: High temperature resistant aluminum silicate cotton is filled between the inner and outer walls of the oven equipment, with a thickness of100mm