The issues that should be noted during the use of stainless steel fire water tanks are prone to the following errors: as the water pump is the outlet pipe of the fire water tank, a pressure pump is often required to meet the pressure requirements of the fire water tank Some people will pull the water pump out of the water pipe and use it as the water pipe for the fire water tank, which is very wrong The main purpose of a booster pump is to meet the water pressure requirements of fire hydrants and automatic sprinkler systems before starting the fire pump Therefore, the booster pump installed on the booster pump should be installed on the water pipe on one side of the booster pump, and the water flow should not be less than the amount required to preserve the initial fire protection The outlet pipe of the fire water tank does not have a one-way valve: some people use the fire water tank to deliver fire water or fire pump water to the fire water tank, and then flow into the fire pipe network These measures reduce the pressure on the fire protection pipeline network and cannot guarantee the full utilization of fire protection equipment. Therefore, it is necessary to use them in the water supply pipeline of the fire water tank and install check valves on the outlet pipe of the fire water tank to prevent fire pump water from entering the tank Setting up fire water tanks in high parts of buildings: In some places, for steel structure roofs of large space buildings, such as theater stages, it is better for designers to set up fire water tanks in the middle layer of reinforced concrete structures with building bearing capacity. However, the height of the nozzles below is not conducive to increasing the head of the booster pump to meet the requirements of high working nozzle pressure The fire water tank is made into an intermediate pool and cannot be provided to the fire protection system by gravity Scsxccom