Product IntroductionIntroduction-Guangpu Guichuan-

High flow ultraviolet sterilizerBoth the inside and outside of the main body are made of 304L or 316L stainless steel material, and the inside and outside of the main body are polished to enhance ultraviolet radiation, ensuring that the disinfected material will not have incomplete disinfection and sterilization during the disinfection and sterilization process.

Equipment featuresFeatures-Guangpu Guichuan-

Ultraviolet disinfection technology has a high sterilization efficiency: the sterilization effect of ultraviolet bacteria and viruses is generally within 1-5 seconds. Other chemical methods (chlorine dioxide and ozone) generally take 30 minutes or even longer to achieve the same sterilization effect of the system.

High sterilization efficiency: UV disinfection is widely used and can effectively kill most pathogenic microorganisms, bacteria, viruses, Escherichia coli, and reduce the total number of bacteria in water.

No secondary pollution: Since UV radiation does not use any chemical agents, it will not pollute water bodies and the surrounding environment, resulting in secondary pollution

Low operating costs, simple maintenance, easy operation, and cost savings.

Small device size: It can be installed nearby in any place with water and power sources, and only needs to be connected to the inlet and outlet and power source to operate.

maintenancemaintenance-Guangpu Guichuan-

Regular cleaning of quartz casingFirst, turn off the power, remove the dust covers on both sides of the sterilizer, take out the lamp tube, remove the end caps, take out the "O" ring, and then slowly remove the quartz tube. When cleaning the casing, use alcohol as a cleaning solution. After cleaning, the operator should not directly touch the surface of the quartz tube with their hands to avoid dirtying and affecting transparency. Align the quartz tube with the water seal holes at both ends, insert the quartz tube with equal clearance at both ends, insert the "O" - shaped rubber ring, slowly and evenly tighten the pressure cap, and do not apply too much force to avoid causing the quartz tube to break. Then conduct a water test. If there is water leakage, gently tighten the pressure cap until there is no water leakage. After that, install the lamp tube and start running.

instructionsDescription-Guangpu Guichuan-

The ultraviolet sterilizer of this device is horizontally installed indoors, with the bracket fixed on a designated foundation or workbench. (Connect the inlet and outlet) The sterilization device is located indoors. In addition to considering the convenience of water supply and drainage and meeting the requirements of the process flow, attention should also be paid to leaving an installation position where the ultraviolet lamp tube and space can be extracted. The electrical control box is installed near the device, with a relative humidity of no more than 80 ℃, no corrosive gases, no conductive dust, and no strong vibration and impact.

This product is a pipeline type ultraviolet sterilizer, with two water outlets that can be selected as the inlet and outlet according to the pipeline direction. It can be placed horizontally or vertically according to user needs. To facilitate the replacement of light tubes and quartz tubes, there should be space of the same length on one side as the equipment.

After product installation, conduct a water test to ensure no water leakage, and then connect the power supply.

After connecting the power supply, the indicator light will turn on to ensure that the lamp head and lamp tube are connected properly. Then, press the "power switch" button on the dust cover and the lamp tube indicator light will turn on. The timer will rotate and wait for 3-5 seconds for the lamp tube to light up. At this time, the equipment will operate normally. After confirming that the lamp tube is on for 3-5 minutes, first open the water valve, and then open the water inlet valve. At this point, the machine will start running.