Characteristics of four column and three beam hydraulic press
The four column three beam structure has strong guiding ability, high vertical accuracy, and stable operation.2. 15T or above adopts a speed increasing hydraulic cylinder, which works quickly and then slowly, with low noise, high efficiency, and low energy consumption.
3. The slider is limited by upper and lower electronic sensors, with a long lifespan and simple operation.
4. Equipped with pressure protection, limit, semi-automatic, and manual control functions.
5. Equipped with infrared hand protection device.
This four column three beam hydraulic press is suitable for the pressing process of plastic materials. Such processes as powder product molding, plastic product molding, cold (hot) extrusion metal molding, sheet stretching, as well as horizontal pressing, bending pressing, flipping, and correction.
The four column three beam hydraulic press has an independent power mechanism and electrical system, which is centrally controlled by buttons and can achieve three working modes: adjustment, manual, and semi-automatic
The working pressure, pressing speed, no-load fast descent and deceleration range of the four column three beam hydraulic press can be adjusted according to the process needs, and can complete the ejector process without three process modes: ejector process and stretching process. Each process has two process actions to choose from: constant pressure and constant stroke. The constant pressure forming process has ejector and automatic return after pressing.
In addition to the above functions, the four column and three beam hydraulic press also has a top out tank and automatic retraction.
This four column three beam hydraulic press product is suitable for various plastic material pressing processes, such as stamping, bending, flanging, etc. It can also be engaged in calibration, pressing, grinding wheel forming, plastic product, rubber product, and powder product pressing forming.
The working pressure, pressing speed, and stroke range of this series of four column three beam hydraulic press products can be adjusted within the specified range according to process requirements, and can achieve two process modes: constant pressure and constant stroke. During constant pressure molding, there is pressure holding and automatic return after compression. The workbench is equipped with an ejector device in the middle, which can be used as a hydraulic pad for the molding process of stretched parts in addition to ejector products. (Optional PLC control and grating protection device)
