Boiler factories are all choosing suitable wet electric fiberglass anodized tubes for themselves. Nowadays, the quality of anodized tubes varies greatly. Choosing a good wet electric manufacturer has brought many hidden troubles to many customers, that is, they do not know how to chooseWet electrostatic precipitator manufacturer.

Wet electrostatic precipitatorAnodized tubes include active deposition, suitable beams, erosion water pipes, and suitable beams. Selection of anodizing cylinderThe electrical conductor made of fiberglass raw material has advantages such as good conductivity and easy erosion. The upper and lower ends of the anodic oxide film are applied and tightened by a suitable pipe, and the upper end of the suitable pipe also serves as an erosion tap water pipe. After this erosion tap water pipe, free online erosion of the anodic oxide film on six sides can be carried out to ensure that the anodic oxide film does not scale. The two layers of tubes on the left and right sides of the anodized film are respectively applied by four applicable beams.

The upper end of the anodic oxide film is fixed to the inner wall of the tower by a beam, while the lower end is adjusted by adjusting mechanisms on both sides to adjust its aspect ratio and tighten the anodic oxide film. Chen actively chose the fiberglass honeycomb structure. The honeycomb structure has a higher utilization rate of the total cross-sectional area compared to the circular steel pipe structure, and the fiberglass raw material has the advantages of good conductivity and long application life.

Wet typeElectrostatic precipitatorThe imprint cathode equipment includes cathode wires, upper and lower hanging devices, and insulation layer boxes. Each anodizing pore industry base is equipped with this cathode wire, which is made of burr type and lead antimony alloy raw materials. The cathode wire is fixed on the upper and lower structures, and the structure is suitable for insulation layer boxes. The suspension rod inside the insulation layer box is made of quartz tube, which is suitable for use. After entering the insulation layer box with warm air, the cathode equipment time and anodizing and the tower maintain a dry and boring insulation layer condition. Carbon fiber conductive glass fiber reinforced plastic anodized tube must be made according to its specificationsRequesting overall planning, only by selecting strict raw materials, reasonable structure and overall mold planning, and choosing suitable forming professional skills, can we produce a wet electrostatic precipitator system that meets the requirementsThe goods.

Among several professional forming techniques, hand lay up forming is now widely used and recognized by too many planning and design institutes. It has low investment, fast progress, and low cost, and has good economic benefits in the short term. However, its overall planning is constrained by the large number of application workers, high labor intensity, high labor costs, and low efficiency. Therefore, pultrusion forming is a promising forming method in large shopping malls today, and is increasingly favored by many anodizing tube manufacturers. During the early development of professional skills, a single enterprise was already proficient in producing high-quality pultrusion formed anodizing tube products, which have been widely promoted in large shopping malls. Fiberglass anodizing tube is used in the profession of fiberglass productsFast goods have now made a long way forward in terms of materials, production processes, inspection methods, and other aspects. We firmly believe that they are expected to follow the national energy-saving and consumption reduction requirements, and conductive anodized tubes will surely enter new opportunities for development,