The feeder is generally referred to as a feeder, but it has different names due to different names in different places, and its essence and function are basically the same.

Feeding machine operating procedures:

The feeder should be installed on a fixed foundation according to the prescribed installation method. Before the official operation of the mobile feeder, the wheels should be wedged with triangular wooden wedges or braked with brakes. To avoid movement during work, when multiple feeders are operating in parallel, there should be a one meter passage between machines and between machines and walls.

Before using the feeder, it is necessary to check whether all operating parts, tape buckles, and load-bearing devices are normal, and whether the protective equipment is complete. The tension of the tape must be adjusted to a proper degree before starting.

The belt feeder should be started with no load. Only after normal operation can the material be fed in. It is prohibited to feed before driving.

When several feeders are running in series, they should be started sequentially from the discharge end. Only after all are operating normally can the material be fed in.

When the tape deviates during operation, it should be stopped for adjustment and not forced to be used to avoid wear on the edges and increased load.

The working environment and the temperature of the delivered materials shall not exceed 50 ℃ and shall not be lower than -10 ℃. Do not transport materials containing acidic or alkaline oils and organic solvents.

Pedestrians or passengers are prohibited on the conveyor belt.

Before parking, the feeding must be stopped first, and the parking can only be done after all the materials stored on the belt have been unloaded.

The feeder motor must have good insulation. Do not pull or drag the cables of the mobile feeder randomly. The electric motor should be reliably grounded.

It is strictly prohibited to pull the belt by hand when it slips, in order to avoid accidents.