Daily maintenance: 1. Clean the dirt, grime, and scale on the forklift. The key components include: front fork and gantry slider, generator and starter, battery electrode fork, water tank and air filter. 2. Check the fastening condition of each component. The key points are: front fork support, lifting chain tension screw, wheel screw, wheel fixing pin, brake, servo screw. 3. Check the reliability and flexibility of the foot brake and servo. 4. Check for leaks, with a focus on: pipe joints, diesel tank, fuel tank, brake pump, lift cylinder, tilt cylinder, water tank, water pump, engine oil pan, torque converter, gearbox, drive axle, main reducer, hydraulic servo, steering cylinder. 5. Remove the sediment from the oil filter.

Second,A-series balanced weight stacker truckThe first level technical maintenance is carried out according to the "daily maintenance" project, and the following tasks have been added. 1. Check the cylinder pressure or vacuum degree. 2. Check and adjust the valve clearance. 3. Check if the thermostat is working properly. 4. Check if the multi-directional directional valve, lifting cylinder, tilting cylinder, steering cylinder, and gear pump are working properly. 5. Check if the gearbox shifting is normal. 6. Check and adjust the gap between the brake pads of the handbrake and foot brake and the brake drum. 7. Replace the oil in the oil pan, check if the crankcase ventilation pipe is intact, and clean the oil filter and diesel filter. 8. Check whether the generator and starter motor are securely installed, whether the wiring terminals are clean and firm, and whether the carbon brush and commutator are worn. 9. Check the tightness of the fan belt. 10. Check if the wheels are securely installed, if the tire pressure meets the requirements, and remove any debris embedded in the tire surface. 11. Due to maintenance work, parts were disassembled and reassembled for forklift road testing. (1) Different levels of braking performance should have no deviation or twists. On steep slopes, the handbrake can stop when tightened. (2) There is no abnormal noise when the engine is running under conditions such as acceleration, deceleration, heavy load, or no load. (3) After the mileage test, check whether the brake, gearbox, front axle housing, and gear pump are overheated. (4) Whether the forklift speed is normal and there is no vibration. 12. Check if the diesel tank inlet filter is clogged or damaged,Scissor type aerial work platformClean or replace the filter. Forklift rental.