Product IntroductionIntroduction-Guangpu Guichuan-

Ultraviolet sterilizerThe strong ultraviolet C light generated by a specially designed high-efficiency, high-intensity, and long-life ultraviolet C light generating device is used to irradiate flowing water. When bacteria, viruses, etc. in water are irradiated with a certain dose of ultraviolet C light (wavelength 253.7nm), the DNA structure of bacteria and viruses will be destroyed, causing immediate death or inability to reproduce offspring, achieving the purpose of sterilization. The automatic cleaning type ultraviolet sterilizer has intelligent features and can automatically clean quartz sleeves to ensure the penetration rate of ultraviolet rays.

Equipment featuresFeatures-Guangpu Guichuan-

Equipped with PLC automatic control, automatic operation, remote monitoring, pneumatic cleaning, safe and efficient, with a long service life;

Good sterilization effect, usually reaching a high sterilization rate in 3-5 seconds;

UV sterilization has a high spectrum and can effectively kill almost all bacteria and viruses;

No secondary pollution, UV sterilization without adding any chemical agents, will not cause secondary pollution to water and surrounding environment, and will not change water quality;

Stable operation, commonly used chlorides and ozone are already highly toxic and flammable substances, while ultraviolet radiation does not have such hidden dangers;

Low total investment, small footprint, no noise, and low operating costs. The level of 1000 tons of water treatment capacity is half of the cost of chlorine disinfection.

maintenancemaintenance-Guangpu Guichuan-

Regular cleaning of quartz casingFirst, turn off the power, remove the dust covers on both sides of the sterilizer, take out the lamp tube, remove the end caps, take out the "O" ring, and then slowly remove the quartz tube. When cleaning the casing, use alcohol as a cleaning solution. After cleaning, the operator should not directly touch the surface of the quartz tube with their hands to avoid dirtying and affecting transparency. Align the quartz tube with the water seal holes at both ends, insert the quartz tube with equal clearance at both ends, and insert the "O" - shaped rubber ring. Slowly and evenly tighten the pressure cap, without excessive force, to avoid causing the quartz tube to break. Then conduct a water test. If there is water leakage, gently tighten the pressure cap until there is no water leakage. Finally, install the lamp tube and start running.

instructionsDescription-Guangpu Guichuan-

The ultraviolet sterilizer of this device is horizontally installed indoors, with the bracket fixed on a designated foundation or workbench. (Connect the inlet and outlet) The sterilization device is located indoors. In addition to considering the convenience of water supply and drainage and meeting the requirements of the process flow, attention should also be paid to leaving an installation position where the ultraviolet lamp tube and space can be extracted. The electrical control box is installed near the device, with a relative humidity of no more than 80 ℃, no corrosive gases, no conductive dust, and no strong vibration and impact.

This product is a pipeline type ultraviolet sterilizer, with two water outlets that can be selected as the inlet and outlet according to the pipeline direction. It can be placed horizontally or vertically according to user needs. To facilitate the replacement of light tubes and quartz tubes, there should be space of the same length on one side as the equipment.

After product installation, conduct a water test to ensure no water leakage, and then connect the power supply.

After connecting the power supply, the indicator light will turn on to ensure that the lamp head and lamp tube are connected properly. Then, press the "power switch" button on the dust cover and the lamp tube indicator light will turn on. The timer will rotate and wait for 3-5 seconds for the lamp tube to light up. At this time, the equipment will operate normally. After confirming that the lamp tube is on for 3-5 minutes, first open the water valve, and then open the water inlet valve. At this point, the machine will start running.

Installation sizeinstallation-Guangpu Guichuan-