1、 Standard orifice plate

★characteristic

It has the characteristics of high measurement accuracy, easy installation, wide range of use, and low cost. Widely used for flow measurement of various media.

★specifications

DN20～300mm

2、 Standard nozzle

★characteristic

It has the characteristics of high temperature and high pressure resistance, impact resistance, long service life, large measurement range, and high measurement accuracy. Suitable for measuring high-temperature and high-pressure steam flow in power plants, heat supply network pipelines, and fluid flow with high flow rates.

There are two forms:A：ISA1932Nozzle (standard nozzle)

B: Long diameter nozzle

★ specifications

D_N＜1000mm

3、 Classic Venturi tube Venturi nozzle

★characteristic

Has low pressure loss,High measurement accuracy,Short length of front and rear straight pipes,The characteristic of long service life. Suitable for flow measurement of water and gas.

★specifications

50＜DN＜3500mm

4、 Wing wind measurement device

★characteristic

It has the characteristics of low pressure loss, short front and rear straight pipes, and stable measurement. Suitable for measuring air volume in circular or rectangular pipes.

★specifications

DN80-4000mm(Or long×wide)

5、 Double Venturi tube

★characteristic

It has the characteristics of low pressure loss and stable measurement, and is suitable for measuring air volume in circular or rectangular pipelines.

★specifications

DN200-4000mm(Or long×wide)

6、 Circular orifice plate, circular orifice plate, eccentric orifice plate

★characteristic

It has the characteristics of being less prone to blockage and having shorter straight pipes at the front and back. Suitable for measuring gases and liquids containing dust, impurities, and large amounts such as blast furnace gas and coke oven gas.

★specifications

DN50-3500mm

7、 Double orifice plate1/4round nozzle

★characteristic

Suitable for various flow rates under low Reynolds number conditions, widely used for flow measurement of liquids and gases with low flow rates.

★specifications

DN25-600

8、 Anuba flowmeter(Also known as averaging tube flowmeter)

★characteristic

It has the characteristics of low pressure loss and easy installation. Suitable for flow measurement of circular and rectangular pipelines.

★specifications

PN＜10DN50～4000

9、 Flow restriction orifice plate

★characteristic

It has the characteristics of current limitation and voltage reduction. Suitable for restricting flow or reducing pressure.

★specifications

DN10～1000